Filter
Top Products
13
DCS-6620G User’s Manual
D-Link Systems, Inc.
Installation Wizard
Installation is now complete.
IMPORTANT:
A hardware reset of the 802.11g PTZ Internet Camera may be required if the Installation Wizard
cannot find the camera. To accomplish this reset, lightly insert a paper clip (or a similar sized
tool) into the reset hole on the side of the camera (see page 132 for the location of the reset
hole). The LED on the front of the camera will begin blinking alternately. When it stops the
blinking cycle continue to hold in the reset button for about 10 seconds.
The opening Installation Wizard screen
will appear and show a MAC address of
the DCS-6620G and an IP Address (which
may or may not be correct depending on
what you have your DCS-6620G connected
to). If you have a DHCP* server on your
network, there will be a valid IP Address
displayed here, indicated by a “Yes” under
the assigned column.
*A DHCP server is a device that supplies
IP Addresses to its clients that are on the
same network.
Click Finish.
To access the Installation Wizard screen, click on the
Installation Wizard Icon on your desktop.