Filter
Top Products
39
DCS-6620G User’s Manual
D-Link Systems, Inc.
Using the DCS-6620G with an Internet Browser
Configuration > Advanced > Network (continued)
Reset IP Address at next boot
Once the DCS-6620G is configured, this box should be unchecked at all times. If the box has been
checked and the connection is lost, run Installation Wizard to find the camera’s IP address.
General Settings
HTTP Settings
Streaming Settings
Can be set to other than the default port 5002 to correspond
with the port opened by the firewall
Can be set to other than the default port 5003 to correspond
with the port opened by the firewall.
Necessary for network identification.
Used to determine if the destination is in the same subnet.
The default value is “255.255.255.0.”
The router used to forward frames to destinations in a different
subnet. Invalid router settings may cause the failure of
transmissions to a different subnet.
Primary domain name server that translates names to IP
addresses.
Secondary domain name server to backup the primary one.
Can be set to other than the default port 80. When the
administrator changes the HTTP port of the DCS-6620G (which
has an IP address of 192.168.0.120) from 80 to 8080, users
must type http://192.168.0.100:8080 in the Web browser bar.
IP address:
Subnet mask:
Default router:
Primary DNS:
Secondary DNS:
HTTP Port:
UDP Video channel port:
UDP Audio channel port: