Filter
Top Products
88
DCS-6620G User’s Manual
D-Link Systems, Inc.
Using IP surveillance Software
Display Options:
In the video displaying frame of each channel, there are two status bars. The upper bar contains
“Camera location” and “time of the remote site.” The lower bar contains “Connection time”
and “Recording time.” All of them, shown in the figure below, can be enabled or disabled here
individually for the status indication. Apply to full screen mode can also be turned on here.
Once it has been checked, the status bar in each channel showing date, location, connection,
and recording time will be shown in both display frame mode and full screen mode.
0 day 00:01
Location (channel number + camera name)
Remote Time
Connection Time (Day:Hour:Min)
Recording Time (Day:Hour:Min)
Monitor Program (continued)
Modulation Mode
You must select the input signal format (NTSC or PAL) for displaying the
original resolution of video stream from DCS-6620G. If you are not sure which
format to select, then leave the input signal format at it’s default (NTSC).
NOTE: You need to select the input signal format according to the camera type or CCD
module type that is connected to the DCS-6620G.