Filter
Top Products
60
DCS-6620G User’s Manual
D-Link Systems, Inc.
Using the DCS-6620G with an Internet Browser
Configuration > Tools > Applications (continued)
Select the weekdays that should perform the following
operations:
Sets the time to stop the operations.
Set the time to start operations. Setting the begin time
the same as the stop time will force the operations to run
continuously.
After a snapshot is taken because of a trigger, another
snapshot will be taken after the configured time in
seconds.
There are 4 conditions related to the digital input and
three windows for motion detection. There can be multiple
selections. Select the appropriate digital input condition
according to the characteristics of the external device.
“High”, “low” indicate external voltage input for level trigger,
while “rising”, “falling” is for edge triggers. There are three
windows shown for the names you defined for motion
detection. “Undefined” will show instead of the window
title if motion detection is not setup yet. An active, named
motion window must be checked for motion detection to
be possible.
Check and save this option to reset the external device at
the digital output back to the original state.
Sets the time delay before restarting to check the trigger
condition when the current condition is triggered.
If you do not wish to set a schedule, this box must be
checked.
Sunday through Saturday:
Snapshots begin at:
Snapshots stop at:
Weekly schedule
All of the time except for
the above schedule:
Event operation
Delay second(s) before
detecting next event:
Take snapshots at second(s)
after event:
Trigger condition:
Reset output: