Epson PhotoPC 700 Digital Camera User Manual


 
4. Extend the retractable plug located on the back of the
charger, or connect the battery charger to the power
cord as shown below.
5. Plug the charger into an electrical outlet. The light(s)
turn red indicating that the charger is working. (If
your charger has 2 lights, wait until both SIDE A and
SIDE B lights turn red.)
When the batteries are fully charged after about two
and half to three hours, the lights go off. To charge
your batteries again, open and then close the charger
again, or unplug the AC power cord then plug it in
again.
Note:
If your battery charger has a cover, do not open it
while charging.
The charger lights flash to indicate changes in battery
temperature and voltage. If the charger lights continue
to flash more than half an hour, the batteries may be
damaged or worn out. Replace them with four new
Ni-MH batteries.
6. After the lights go off, unplug the charger. To avoid
overcharging, don’t leave the charger plugged in for
long periods of time after the lights go off.
7. Just after charging, the batteries are very hot
(approximately 65°C). Wait one hour until the
batteries cool before removing them from the charger.
8. Before storing the charger, close the retractable plug or
disconnect the AC cable.
5
R
Poppy+ Rev.C
A5 size Chapter 5
5/8/98 pass 1
Camera Options
5-9