Filter
Top Products
147
Settings
Store information from a barcode reader or GPS
connected to a 10-pin terminal as Exif information.
[BCR 1 SHOT]
Read barcode information for each shot and store it as
comment information. Pictures cannot be taken without
reading a new barcode.
[BCR CONTINUOUS]
Store registered barcode information as comment
information in every file. To erase the registered
information, read the “barcode eraser” on this page or
delete the letters registered in the [IMAGE
COMMENT].
[GPS]
Store information from GPS device allowing latitude,
longitude, altitude and UTC (standard universal
coordinated time) to be recorded with photographs.
[OFF]
No store barcord or GPS information is retrieved.
MEMO
When the barcode information is stored, BCD is
displayed in the control panel.
Z Connecting to barcode reader
You can use the barcode reader with a D-sub 9-pin
connector (commercially available).Connect the barcode
reader to the camera using MC-35. See the barcode
reader instruction manual for details.
Barcode reader setting
• Baud rate: 4800 bps
• Data length: 8 bit
• Parity check: –
• Stop bit: 1 bit
• EOF: CR+LF
Z Barcode eraser
Use the barcode reader to read the barcode below to
erase the last barcode information.
Continued Q
BARCODE READER/GPS
How to use the SET UP menu (➝p.138)