Hitachi VZ-HD4000A Camcorder User Manual


 
14
Introduction
Setting the VIDEO SELECT
Switch
This switch allows you to select
the video format of the signal to
be output from the VIDEO OUT
terminals.
Caution
Be sure to set this switch before
you turn on the camera. It can
also be set when in the standby
mode. (P. 29)
Be sure to use a Phillips driver
when changing the switch
position.
Using anything other than the
designated screwdriver may
damage the grooves.
This camera does not have
a function that automatically
matches the video output signal
to the connected monitor’s
resolution. Be sure to congure
the setting so it matches the
monitor's resolution.
The Hi-Vision video signal
outputs a distortion-free image
on monitors with an 16:9 aspect
ratio.
Set it to the
desired video
format.
Switch
position
Video output format
0* 1080i/59.94
1
1080p/59.94[VZ-HD4900A]
2 720p/59.94
3 1080p/29.97
4
5
6
7 Serial control
8 1080i/50
9 1080p/50[VZ-HD
4900A
]
A 720p/50
B 1080p/25
C
D
E
F
* This is the factory default setting.
Caution
VZ-HD4000A does not output
1080p/59.94 or 1080p/50.
The HD-SDI output does
not output 1080p/59.94 or
1080p/50.
When the video output format
is set to serial control (switch
position 7), the video output
format can be set using an
external device; however, the
video output format setting
is reected after the power is
turned back on.