Filter
Top Products
48 49
Appendix
If this Happens Way to Resolve the Problem
Refer to
Page
Image Related
The brightness of
subjects end up
changing.
When the brightness of the background
changes, the brightness of your subject
will also change due to the auto exposure
adjustment of the camera.
―
The area around
bright things and the
border of dark things
end up colored.
This is not a fault. Devise a way to shoot,
such as changing the camera orientation,
so there is a smaller difference in
brightness. Switching to the Program AE
Auto mode and changing the aperture
limit may improve this.
P. 40
Images are out of
focus.
The zoom doesn’t
work.
Are you trying to shoot a subject that is
hard for the autofocus to bring into focus?
Try focusing manually.
P. 32
Is the camera in the manual focus mode?
Focus the camera manually or cancel the
manual focus mode.
P. 32
Is there a cell phone or radio nearby?
Move it away from the camera and turn
the power on again.
P. 4
If none of the above apply, try turning the
power off and back on again.
―
Communication with External Devices
Unable to use
external control
even when
connected to an
external device.
Check and make sure the external device
is properly connected to the camera.
P. 26
Make sure the camera is turned on. P. 26
Check and make sure that the
serial
communication baud rate and
RS-232C/RS-422 selections are
correct on the System Select switch. If
devices are connected in a daisy chain,
the positions of the switch above must be
the same.
P. 15