Filter
Top Products
28
Direct Remote Control Function
Before Use
lThis chapter describes the
functions that can operate the
camera directly via remote control.
Refer to P. 37 for functions that use
menu screens.
lRemote control buttons are
indicated as [Button Name].
For example, [POWER] refers to
the power button on the remote
control.
lWhen using the remote control,
point it at the remote control
receiver (P. 12) on the camera.
Selecting Remote
Control Codes
1
Setting the camera’s
remote control codes
Set the remote control
codes with the SYSTEM
SELECT Switches
– (remote control code
selections) (P. 15).
2
Press the CAMERA
SELECT Button
(CAMERA*) on the remote
control and operate the
designated camera
Ex.: To operate CAMERA1, set the
SYSTEM SELECT Switches to
ON, OFF, OFF:RC1.
Refer to “Remote Control Indicators”
on P. 36 for the meaning of lighted
remote control indicators.
Turning the Power ON
STANDBY lamp
POWER lamp
1
Press [POWER] on the
remote control
The power comes on.
(The POWER lamp lights
and the STANDBY lamp
goes off)
The camera automatically
goes through pan and tilt
movements and then returns
to the home position.
2
Turn on the devices
connected to the camera
Hint
When the POWER lamp is lit,
pressing [POWER] shifts it into
standby mode.
(The POWER lamp goes out and
the STANDBY lamp lights)
If you press [POWER] again, the
power comes back on.
Caution
When the power is plugged in,
the head of the camera will rst
start to move.
Direct Remote Control Function