Filter
Top Products
Page 4
TM-4200GE Software
Software Introduction
3. Click the Change or Remove button as shown in Figure 3 on page 4.
FIGURE 3. Change and Remove Buttons
1.4.4 Quick-Start
Use the following quick-start process when the Camera Interface Application is installed on your PC.
1. Connect the camera. The Hirose pin layout is shown in Table 1 on page 6. Both the Hirose and the
network cable (RJ-45) are illustrated in Figure 6. Verify that both LED’s on the RJ-45 connector
are green.
2. Run the Camera Interface Application.
3. Click Detect. Assign a suitable IP address to the camera. The window shown in Figure 2 appears.
FIGURE 4. Network Device Finder Window
4.
Select the appropriate camera from the list, similar to the window shown in Figure 5 on page 5 and
click OK.