Filter
Top Products
Page 29
TM-4200GE Software
GigE Series Camera Serial Commands
TABLE 5. Command Responses
Command Parameter
End of
Cmd Ack. Response Description
Miscellaneous
:DUL= X <cr> :o<cr> Single Tap/Dual Tap Selection (X = 0
Dual Tap, X = 1 Single Tap)
:DDP= X <cr> :o<cr> Set Output Data Depth (X = 0 8-bit, X =
1 10-bit, x = 2 12-bit)
:CCS= X <cr> :o<cr> Select Camera Control signals (X = 0 CL
Conn, X = 1 Hirose Conn)
:TAH= X <cr> :o<cr> External Trigger Polarity (X = 1 Active
High, X = 0 Active Low)
:TPTN X <cr> :o<cr> Enable/Disable Test Pattern (X = 1
Enable, X = 0 Disable)
:CAM? <cr> :o[model]<cr> Inquire Camera Model
:VER? <cr> :o[version]<cr> Inquire MPU firmware version
:SGE= X <cr> :o<cr> Set Digital Output Interface
(X = 0 CameraLink, X = 1 GigE)
:CCD= X <cr> :o<cr> CCD information (X = 1)
:PuLX X <cr> :o<cr> Password (X = 1 Administrator, X = 0
Users)
Note: If a command is not accepted for any reason, the camera will return a “nack” response. “:e”
<cr> *Not available yet.
Command Parameter End of Cmd Description
Byte 1, 2 Master Gain Master Gain (H'0000 - H'0FFF: -3dB - +12dB)
Byte 3, 4
R Channel
Fine Gain R Channel Fine Gain (H'0000 - H'0FFF)
Byte 5, 6 Master Offset Master Offset (H'0000 - H'0FFF)
Byte 7, 8
R Channel
Fine Offset R Channel Fine Offset (H'0000 - H'0FFF)
Command Parameter End of Cmd Description
Byte 9
Function Flag
0
Bit 0 Scan Area 0
0000=2048x2048 0001=2048x1000
0010=2048x500 0011=2048x250
Bit 1 Scan Area 1
0100=2x2 binning of 2048x2048
1111=User Programmable Scan Area
Bit 2 Scan Area 2
1000=Digital Zoom x1 1001=Digital Zoom
x2
Bit 3 Scan Area 3
1000=Digital Zoom x3 1001=Digital Zoom
x4
Bit 4 Rsvd
Bit 5 Rsvd
Bit 6
Pixel Output
Order 0 00=<---<--- 01<=<------>
Bit 7
Pixel Output
Order 1 10=<<------
Byte 10
Function Flag
1
Bit 0 Shutter 0
Continuous Mode: 0000 - 1001=Continuous
preset shutter 0 - 9
Bit 1 Shutter 1 Trigger Mode: