Filter
Top Products
41
Playing, Skipping and Stopping Recorded
Images
Control using the [PLAY], [SKIP], and [STOP(PB)] buttons.
Ⅵ Control using the [PLAY], [SKIP], and
[STOP(PB)] buttons on the front panel
ⅷ Playing Back
1 Press the [PLAY] button
●
Playback starts from the date/time indicated on the
[Master Time] of [Time Navigation].
●
Images are played back according to the angle of the
shuttle dial (x1/20, x1/5, x1, x2, x5, x10, x20).
ⅷ Skipping
1 Press the [SKIP] button
●
The [SKIP] buttons have the following functions.
Memo :
●
“Sequence” indicates a certain block of images that are recorded
during motion detection.
●
Recorded images are stored in the database.
Note :
●
The [SKIP] buttons are only enabled when a camera has been
selected.
●
During simultaneous recording and playback, an
A
After
Database End
B
message may appear as playback catches up
with recording during playback near the current time.
●
When recording is set to be triggered by motion/event
(
A
Page 57), recording will not start unless a motion/event
occurs. During playback near the current time, however, the
image that is not recorded will also be played.
ⅷ Stopping
1 Press the [STOP(PB)] button
●
Playback stops.
ⅷ Enlarging a Display
●
Entering the number of the selected camera switches to an
enlarged display.
●
To return to normal display, enter the camera number of the
enlarged display.
Adjusting the Playback Speed (Jog/
Shuttle Playback)
You can adjust the playback speed by turning the jog dial/shuttle
dial on the front panel.
Ⅵ Shuttle Playback
●
Rotate the shuttle dial during playback or when playback is
paused to start fast forward, fast reverse or slow playback.
Memo :
●
The playback speed that is indicated during fast forward or fast
reverse playback by rotating the shuttle dial is an approximate
value. The speed may differ depending on the conditions, such
as the playback mode (multi-view, single view) and the recording
mode (motion detection, recorded frame rate).
Ⅵ Jog Playback
●
Rotate the jog dial to play back frame by frame.
●
Rotate the dial clockwise to play back a single frame in the
forward direction, and rotate the dial counterclockwise to play
back a single frame in the reverse direction.
●
Release the dial to pause the playback. However, when frames
are played back successively in the forward or reverse direction,
playback may continue momentarily after the jog dial is released.
Note :
●
The jog dial is only enabled when a camera has been selected.
●
When the playback speed is adjusted or when playing back at
high speed during recording, the frame rate of the recording may
decrease. Check the performance meter while adjusting the
playback speed to ensure that the display does not turn red.
S Moves to the first image in the previous sequence.
Moves to the first image in the database of the selected
camera when the button is pressed and held down.
T Moves to the first image in the next sequence. Press and
hold down the button to move to the latest image in the
database of the selected camera.
NVRViewer
[Master Time] area
[Time Navigation] Section
[Go To] Button
[Browse] Screen
still
REV FWD
Jog/Shuttle dial
Shuttle Dial (External)
Jog Dial (Internal)