Filter
Top Products
57
Item Preset Values Description
ERecording Settings (continued)
Enable speedup
On motion
On event
Enables you to specify whether to execute recording with a higher maximum frame rate when
motion is detected or when an event occurs.
When [On event] is selected:
Specify the starting and ending events in the [Start] and [Stop] fields respectively.
The speedup recording frame rate uses the [Frame Rate] in the [Speedup Settings]
A
item.
When to store
images in
database
Always
Never
ⅷ Conditionally
Always : Select this check box to record images at all times.
Never : Do not perform recording in the recording control mode. Record
starts when the [REC/STOP] button is pressed.
Enables you to specify the recording conditions in recording control mode. If you have
selected [Conditionally], specify the following fields as well.
On motion : Select this check box to record all images for which motion has been
detected.
On event : Select this check box to record all images from the occurrence of an
event until the next event occurs regardless of motion. Specify the
starting and ending events in the [Start] and [Stop] fields
respectively.
Memo :
●
For details on events, refer to [Camera Input/Output Port and Events] (
A
Page 95).
Note :
●
The [ALARM] indicator on the front panel lights up regardless of the recording status when
the motion or event specified in [When to store images in database] occurs. Press the
[ALARM CLEAR] button to turn off the light of the [ALARM] indicator.
( )seconds pre/post recordings on motion/event:
You can record images preceding and following a detected motion or event. Specify the time
interval to record in the number of seconds before and after the occurrence. (
A
Page 135)
Memo :
●
Do not set to
A
0 seconds
B
.
●
If Offline is selected in [Scheduler...], images will not be recorded.
●
This setting has no impact on manual recording, emergency recording, and [EXT REC IN]
recording.
F Datebase
Settings
^
Enables you to specify the database settings. (
A
Page 110)
G Motion
Detection
Settings
^
Motion Detection.. Enables you to specify the two parameters for motion detection, namely [Sensitivity] and
[Motion Sensitivity]. (
A
Page 104)
Motion Color.. Enables you to specify the color to be used for highlighting detected motion.