Filter
Top Products
B-2
Symptom Cause Remedy
The shutter does not
release.
The Main switch is set to
(
).
Set the Main switch to
(A)
The subject is not
focused. (The in-focus
indicator is blinking in
the viewfinder.
Press the Shutter button
again halfway. If the
subject still cannot be
focused, refer to
“Difficult Subjects for
Autofocus” in Chapter 8.
The PC Card is full Replace the PC Card or
delete some images
No PC Card in camera Insert a PC Card
“
bc “ blinks in the
Top LCD panel.
The camera has
undergone some type of
malfunction.
Remove the battery from
the camera and reload it.
If the blinking “
bc “
indicator disappears, the
camera will operate
normally.
If the “
bc “ indicator
does not stop blinking
after repeating the above
operation several times,
there is a malfunction in
the camera. Take the
camera to your service
representative.
The Frames
Remaining indicator
on the Back LCD
panel reads 0.
The PC Card is full Insert a different PC
Card or delete some
images from the PC
Card.
The battery icon on
the back LCD panel
shows that the battery
is low.
Battery is low Recharge the battery,
replace it with a freshly
charged battery, or, if
working indoors, connect
the AC adaptor.
Exposed a burst of
images and the Card
icon continues to
flash.
It takes time to save a
burst of images.
Wait a few seconds.
L