Filter
Top Products
50
Setting
Setting of Update Method for Memory Channel to Store Measurement Value
There are 100 directories to store measurement value from M000 to M100 and each can
store one value, therefore 101 in total.
Here, whether measurement value is to store automatically or by pressing MEMORY key is
selectable for every measurement.
See p.50 for details on protection of stored data when data storage is to perform on
memory channel with another measurement value.
∗ Setting at the shipment from factory : AUTO NUNM
Operation Procedure
1.
Press
ESC
key when menu or target
value setting menu appears.
Measurement screen appears on LCD screen.
2.
Make sure that [ ] appears on left
bottom indicating this instrument is
has not been set for SHIFT mode.
If [SFT] appears instead, it means that
instrument is to operate in SHIFT mode.
Press SHIFT key to cancel SHIFT mode.
3.
Press [MENU] key twice.
Menu 2/4 screen appears on LCD screen.
4.
Press either
or
key to select
[MEMORY MODE] and then
ENTER
key.
Inversion cursor moves from
[MEMORY MODE] to right to change
update method of memory channel.
2 3 1, 7 6 4, 5
MEMORY
MODE
CH00:
<
DEFAULT
>
Lv 20.80
cd/m
2
x 0.4476
y 0.4477
<
MODE
>
SINGLE
[ ] [ 2° ]
<
ANGL
>
1
°
VIEW
<
SPD
>
AUTO
<
SYNC
>
200.00Hz
<
LENS
>
STANDARD
<
MEM
>
AUTO NUM
<
MEMORY DATA
>
MOOO:(NO DATA)
Lv ------
x ------
y ------
<
MENU
>
2/4
OBJECTIVE LENS STANDARD
DISPLAY DIGITS 4 FIGURES
MEMORY MODE AUTO NUM
DATA PROTECT ON
BREAK : [ESC]
[ ] [ 2° ]
<
MENU
>
2/4
OBJECTIVE LENS STANDARD
DISPLAY DIGITS 4 FIGURES
MEMORY MODE AUTO NUM
DATA PROTECT ON
BREAK : [ESC]
[ ] [ 2° ]