Filter
Top Products
90
Maintenance
Cleaning the filter
Check that dust or dirt does not adhere to
the IR/Low Pass Filter by holding the cam-
era and light shines on the filter.
* Dust and dirt is more conspicuous when light is
shined on the filter.
Carefully remove all dust with a lens blower
that is available on the open market.
* When using a blower, make sure the tip does not
come into contact with the surface of the filter.
* Use a lens blower that is not equipped with a
brush. The use of a blower with a brush may re-
sult in the surface of the filter being scratched.
Mamiya ZD Back maintenance/checks
• Always place the lens selector lever in the L when this unit is not going be
used.
• Remove the lithium ion battery and store it in a well ventilated place when
this unit is not going to be used for an extended period.
•Never try to dismantle or modify the camera in any way.
• The connections could become loose or corroded if they are damaged or
become dirty.
• Use this unit carefully to avoid dropping or banging against other items.
• Use a damp cloth that has been soaked in water and then wrung to clean the
camera if it has been exposed to salty air.
• This unit may be damaged if used/stored in areas where chemical gasses
are present.
• Wipe with a soft, dry cloth when cleaning. Do not use solvents, etc. The
product can cause discoloration.
• Before using this unit after it has been in storage for an extended period, it is
important that either you or your nearest customer service center carry out a
few simple checks to make sure this unit is operating correctly.
08_ZD back_E_p089-090 07/3/9, 20:4390