Filter
Top Products
90
Item
Display
mode
Description of settings
[INTERVAL
REC]
<CAMERA>
(AVCHD
mode only)
Scenes changing slowly over a long period are recorded as short movies by
providing a recording interval. One frame is recorded in each recording time
period that has been set, and in the AVCHD mode 24 frames (PAL 25 frames)
form a one-second video.
[OFF], [1SECOND], [10SECONDS], [30SECONDS], [1MINUTE], [2MINUTES]
When INTERVAL REC is enabled, set the recording format as follows. If the
recording format is not set to the following, the [INTERVAL REC] item of the
[RECORDING SETUP] screen is grayed out and cannot be enabled.
When [SYSTEM FREQ] = [59.94Hz]: [PH 1080/24P]
When [SYSTEM FREQ] = [50Hz]: [PH 1080/25P]
•
When set to [PH 1080/24P], TC RECRUN is xed to NDF.
•
The maximum shooting time is 168 hours.
•
Audio recording is disabled.
[TIME STAMP] <CAMERA> Enables a function to superimpose [DATE]/[TIME] information over the shot
images.
[ON]: The information set in the [DATE]/[TIME] item is superimposed.
[OFF]: Date and time information are not superimposed on the image.
[PS/PH AUDIO
MODE]
<CAMERA>
(AVCHD
mode only)
Selects the format of audio recording when [REC FORMAT] = PS/PH.
[LINEAR PCM]: Recording is performed in uncompressed LPCM.
[Dolby Digital]: Recording is performed in Dolby Digital.
•
The camera is xed to Dolby Digital other than PS/PH mode.
•
Content recorded with [LINEAR PCM] cannot be played back on our previous
model.
[AUDIO
LIMITER CH1]
<CAMERA> Enables the limiter function on CH1 audio input.
[ON]: Level is reduced only when input exceeds limit (adjustable using
<AUDIO LEVEL> knob).
[OFF]: No limiter (adjustable using <AUDIO LEVEL> knob)
[AUDIO
LIMITER CH2]
<CAMERA> Enables the limiter function on CH2 audio input.
[ON]: Level is reduced only when input exceeds limit (adjustable using
<AUDIO LEVEL> knob).
[OFF]: No limiter (adjustable using <AUDIO LEVEL> knob)
[MIC GAIN1] <CAMERA>
Sets the input level of the external microphone connected to the AUDIO INPUT1
terminal.
[-40dB], [-50dB], [-60dB]
[MIC GAIN2] <CAMERA>
Sets the input level of the external microphone connected to the AUDIO INPUT2
terminal.
[-40dB], [-50dB], [-60dB]
is the factory default mode.