Filter
Top Products
92
[AV OUT SETUP] screen
Item
Display
mode
Description of settings
[SDI&HDMI
OUT SEL]
<CAMERA>
<PB>
(AVCHD
mode only)
Sets the video format of the <SDI OUT> and <HDMI> output.
[1080i/720P]: Outputs at the resolution set in [REC FORMAT]. Outputs at
1080/60i or 1080/50i in PS mode.
[DOWN CONV]: When [SYSTEM FREQ] = [59.94Hz], <SDI OUT> is output
at 480i, while <HDMI> is output at 480P. When [SYSTEM
FREQ] = [50Hz], <SDI OUT> is output at 576i, while
<HDMI> is output at 576P.
[SDI OUT] <CAMERA>
<PB>
Sets the video output from the <SDI OUT> terminal.
[ON]: Video is output from <SDI OUT>.
During this time, simultaneous LCD monitor and viewnder display is
not supported. When using the viewnder, please close the monitor.
[OFF]: No video is output from <SDI OUT>.
[SDI 24PsF] <CAMERA>
<PB>
(AVCHD
mode only)
Sets the video format output from <SDI OUT> to 24PsF.
[ON]: Operates only when [REC FORMAT] = 1080/24P. If it is set to [ON],
VFR operation is disabled. During 24PsF output, HDMI output is
halted.
[OFF]: SDI output is in the 1080/60i format.
•
When [SYSTEM FREQ] = [50Hz], this item is not available.
[SDI EDH] <CAMERA>
<PB>
Sets superimposition of EDH onto the <SDI OUT> during <SDI OUT> output.
[ON]: Superimposes EDH.
[OFF]: Does not superimpose EDH.
[DOWNCON
MODE]
<CAMERA>
<PB>
(AVCHD
mode only)
Switches down-conversion output mode.
[SIDE CROP]: Crops the left and right edges. Images output from the
external output terminals <VIDEO OUT>, <HDMI>, <SDI
OUT> will have portions which extend beyond the edges of
the screen and cannot be seen.
[LETTER BOX]: Adds black bands at the top and bottom of the image.
[SQUEEZE]: Squeezes images horizontally.
[HP MODE] <CAMERA> Selects the sound heard from the headphones.
[LIVE]: The sound input from the microphone is output as is. This
setting is selected when delays in the sound are annoying.
[RECORDING]: The sound in the status to be recorded (the sound
synchronized with the images) is output.
[TEST TONE] <CAMERA> Sets test tone output to channels 1 and 2 when BARS setting is ON.
[LEVEL1]: Outputs the 1 kHz test tone.
[LEVEL2]: Test tone is output at lower volume than LEVEL1.
[OFF]: Does not output the test tone.
is the factory default mode.