29
<Selecting the USER CLIP NAME recording method>
From the menu bar, select [OPERATION] → [DEVICE
SETUP] → [META DATA] → [USER CLIP NAME] item.
Either [TYPE1] or [TYPE2] can be selected as the USER
CLIP NAME recording method.
[TYPE1]
[TYPE2]
1 Concerning the COUNT value
The COUNT value is indicated as a 4-digit number.
When the clip metadata has been loaded and [TYPE2]
has been selected as the recording method, the COUNT
value is incremented by 1 each time a shot is taken and a
new clip is generated.
It can be reset by following the sequence of steps below.
From the menu bar, select [PROPERTY] → [DEVICE] →
[META DATA] and then the [USER CLIP NAME] item.
The window shown below now appears. Align the pointer
with [COUNT RESET] and press the SET button to reset
the COUNT value to 1.
Concerning the incrementing of the COUNT value
of USER CLIP NAME with clips exceeding 4 GB
When a P2 card with a memory capacity of 8 GB or
more is used in this unit, if a one-time continuous
recording exceeds the prescribed duration (refer to the
section on “Dividing clips over 4 GB in length” on page
9) or if a one-time recording extends over more than one
card, the recording concerned will automatically be
undertaken as a separate clip. At this time, the COUNT
value is automatically incremented by 1 and recorded.
Example of recording (DVCPRO50) a clip on one
P2 card:
Example of recording a clip on two P2 cards:
If the clip thumbnails are shown and their properties are
displayed using a P2 series product, the thumbnail and
COUNT value of clip 1 will be displayed.
<Clear the uploaded metadata>
Select [OPERATION] → [DEVICE SETUP] → [META
DATA] → [INITIALIZE] from the menu bar, and press the
SET button. Select “YES” when the confirmation screen
is displayed.
