Filter
Top Products
68
Rack mounting
The memory card recorder can be mounted into a 19-inch
standard rack using the optional rack-mounting adaptors
(AJ-MA75P).
For the installation rails, it is recommended that the 18-inch
rail and bracket (model number CC3061-99-0400) by
Chassis Trak be used. (The complete slide rail and bracket
deck is not available from Panasonic.)
For further details, consult your dealer.
(1) Attach the inner members of the slide rails
Refer to the figure below for the locations where the
screws are to be attached.
ABCDEFGH
Notes:
•The length of the screws used is subject to
restriction. (B, H: 10 mm, F: 6 mm)
•Attach the inner members at the same symmetrical
positions on the left (L) side.
•Fix the members in place using 3 screws on each
side (total: 6 screws).
•The letters “A” to “H” are not actually marked on
the side panels.
(2) Attach the outer member brackets to the rack
Check that the height is the same for the left and right
brackets.
(3) Remove the four screws at the front for
attaching the left and right side panels
(4) Attach the AJ-MA75P rack mount adapter
using the removed 4 screws
(5) Remove the 4 rubber legs from the bottom of
the memory card recorder, and install the
memory card recorder in the rack
After the memory card recorder has been installed,
check that it moves smoothly along the rails.
Notes:
•Keep the temperature inside the rack from 41°F to
104°F (5°C to 40°C).
•Bolt the rack securely to the floor so that it will not
topple over when the memory card recorder is
drawn out.
Locations where the screws are secured on the right
(R) side of the inner members of the slide rails
Inner member
Rack-mounting adaptors
EIAJ Standard rack
Fasten it to the rack
with set screws.