Filter
Top Products
Operating Instructions
34
• IP address
• Subnet Mask
(Static Only)
• If your ISP or network administrator specifies the IP
address and subnet mask, enter them in each data field.
• If you use the camera on the LAN, set the IP address in the
same subnet mask as your PC (see page
103).
• Set 4 digits (0—255) and 3 periods such as
"192.168.0.253". But "0.0.0.0" and "255.255.255.255" are
not available.
Host Name
(DHCP Only)
• If your ISP uses the DHCP function which automatically
assigns the IP address to the camera, enter the ISP-
assigned host name. (Host name may be used as an
authentication.)
• Enter ASCII characters for the host name (see page 111).
But [Space], ["], ['], [&], [<] and [>] are not available.
Default Gateway
*1
(Static/DHCP Only)
• If you have the assigned Default Gateway address by your
ISP or network administrator, enter it in this data field.
• Set 4 digits (0—255) and 3 periods such as
"192.168.0.253". But "0.0.0.0" and "255.255.255.255" are
not available.
DNS Server
Address
*1
(Static/DHCP Only)
• DNS server address is required in the following conditions.
• Transferring camera images by E-mail or FTP
• Setting cameras by their host names on the Multi-
Camera Setup page
• Using the Viewnetcam.com service
• If you have the assigned DNS server addresses by your
ISP or network administrator, enter them in this data field.
They usually have two addresses.
• Set 4 digits (0—255) and 3 periods such as
"192.168.0.253". But "0.0.0.0" and "255.255.255.255" are
not available.
Setting Description