Operating Instructions
90
3.1.7 Resetting the Camera to Factory Default
All camera settings are reset to factory default directly after the Execute button is
clicked. To restore the wireless connection, access the camera by using the wired
connection and set up the wireless configuration. (See Getting Started.)
1. Click [Reset to Factory Default] on the Maintenance page.
2. Click [Execute].
• The indicator blinks orange, and then turns off for 10 seconds.
• All camera settings (user name, password, IP address, subnet mask etc.)
are reset to factory default.
• If the camera is reset to factory default, the network connection mode
changes to [Automatic Setup]. Reconfigure the camera seeing
Installation/Troubleshooting.
Notes
• The internal clock will not be reset, but the time format will return to AM/
PM mode (see page
43). Set it again.
• See page 94—page 101 for default settings.
• Pressing the FACTORY DEFAULT RESET button resets the camera to the
factory default (see page
93).
• All buffered images are deleted when resetting the camera to factory
default.
• The reset operation takes about 1 minute.
• Do not turn off the camera during the reset operation.