Filter
Top Products
6. If you want to change the picture contrast, move the
"I" cursor for LEVEL and adjust the level.
Note:
If operation of the controller's IRIS (OPEN, CLOSE)
buttons during operation is done after the menu is
closed, the LEVEL on the CAMERA menu is reflect-
ed and stored for these settings. However, if the
camera is in a preset position, it is reflected as a
parameter of the preset position. To return to the ini-
tial factory default level, hold down the system con-
troller's
A button.
7. Move the cursor to RET and press the CAM (SET)
button to return to the CAM SET UP menu.
● Shutter Speed Setting (SHUTTER)
Move the cursor to SHUTTER and select the elec-
tronic shutter speed with the joystick. The electronic
shutter speed changes as follows with the joystick:
** ALC CONT **
BACK LIGHT COMP
BLC
MASK SET
LEVEL
RET
OFF
••••|••••
- +
** ALC CONT **
BACK LIGHT COMP
BLC
MASK SET
LEVEL
RET
OFF
••••|••••
- +
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET SPECIAL2
OFF
ALC
AUTO
ON(MID)
OFF
INT
ATW1
OFF
AUTO L
OFF (1/60) 1/100AUTO
1/10 000 1/4 000 1/2 000 1/1 000
1/250 1/500
-44-
(2) ALC Mode with BLC OFF
1. Move the cursor to BLC and select OFF. (When you
select MANUAL, BLC is not available.) MASK SET
appears on the menu.
2. Move the cursor to MASK SET and press the CAM
(SET) button. The 48 mask areas appear on the
monitor screen. The cursor is blinking in the top left
corner of the screen.
3. To mask an area where backlight is bright, move the
cursor to the area and press the CAM (SET) button.
The mask turns white. Repeat this procedure to
mask the desired areas.
4. To cancel a masked area, move the cursor to the
area, and press the CAM (SET) button. To cancel all
masking areas, press the F3 button of WV-CU650.
For WV-RM70, press the right and left switches
simultaneously.
5. After masking is completed, press the MON (ESC)
button. The 48 mask areas on the monitor screen
disappear and the ALC CONT menu appears.
Blinking
Blinking
Blinking
Turns to white