Filter
Top Products
-45-
• In the AUTO mode, an object is clearly imaged
under highlighted conditions by using the combina-
tion technology of iris and shutter functions.
Note:
When the selected shutter speed caused flicker
on condition that fluorescent lamps stay on,
change this setting to 'OFF'.
● Gain Control [AGC ON (LOW/ MID/
HIGH)/OFF]
Move the cursor to AGC and select ON (LOW), ON
(MID), ON (HIGH) or (OFF) with the joystick.
Notes:
• Even if AGC is set to ON and if the noise reduction
function is enabled, afterimages may be produced
by shooting a moving object or by panning or tilting
the camera.
• For more information, refer to Digital Noise
Reduction on page 49.
● Electronic Sensitivity Enhancement
(SENS UP)
Move the cursor to SENS UP and select the desired
electronic sensitivity enhancement mode with the joy-
stick. The electronic sensitivity enhancement mode
changes as follows with the joystick:
Note:
While the SENS UP function is selected, noise or
spots may appear in the picture when the sensitivity
of the camera is increased. This is a normal phe-
nomenon.
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET SPECIAL2
OFF
ALC
AUTO
ON(MID)
OFF
INT
ATW1
OFF
AUTO L
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET SPECIAL2
OFF
ALC
AUTO
ON(MID)
OFF
INT
ATW1
OFF
AUTO L
X2 AUTO
OFF
X4 AUTO X6 AUTO X10 AUTO
X16 AUTO
X32 AUTO X2 FIX
X6 FIX X10 FIX X16 FIX X32 FIX
X4 FIXOFF
● Synchronization (SYNC)
Move the cursor to SYNC and select LL or INT with the
joystick.
Important Notices:
1. The priorities of SYNC modes are assigned as fol-
lows:
1. Multiplexed vertical drive (VD2) (highest priority)
2. Line-lock (LL)
3. Internal sync (INT) (lowest priority)
2. To use internal sync, select INT.
3. Whenever the vertical drive pulse (VD2) is supplied
to the camera, the camera sync mode is automati-
cally switched to the multiplexed vertical drive pulse
(VD2) regardless of the selected sync mode.
Line-lock Sync Mode (LL)
1. Move the cursor to SYNC and select LL with the joy-
stick. The LL sync mode is not available when the
multiplexed vertical drive (VD2) pulse is supplied.
2. After selecting LL, press the CAM (SET) button.
The SYNC menu appears on the monitor screen.
3. Supply the video output signal of the camera to be
adjusted and the reference video output signal to a
dual-trace oscilloscope.
4. Set the dual-trace oscilloscope to the vertical rate
and expand the vertical sync portion on the oscillo-
scope.
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET SPECIAL2
OFF
ALC
AUTO
ON(MID)
OFF
INT
ATW1
OFF
AUTO L
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET SPECIAL2
OFF
ALC
AUTO
ON(MID)
OFF
LL
ATW1
OFF
AUTO L