Filter
Top Products
10
SW3
SW4
OFF
ONSW2
1 2 3 4
Installation
(The installation work must be performed by your dealer without fail.)
$Setting the installation direction selector switch and landing
characteristics
Set the switches as follows to perform a stand-alone installation and/or to select the
landing characteristics. (Suspended installation and soft landing are the factory
settings.)
1. Remove the four head cover screws, and remove the cover slowly. (Take care not to
disturb the tally LED lamp wiring connections when removing the cover.)
2. Set the SW2, SW3 and SW4 switches on the front printed circuit board as follows.
For suspended installation:
Set SW3 and SW4 to their left-side positions (HANGING). (Factory setting)
For stand-alone installation:
Set SW3 and SW4 to their right-side positions (TOP).
For a soft landing:
Set SW2 switch No.4 to its top (ON) position. (Factory setting)
For a precise landing:
Set SW2 switch No.4 to its bottom (OFF) position.
3. Upon completion of the settings, return the rotary head cover to its original position,
and secure it with the screws (while taking care not to pinch the wires).
<Notes>
OBefore setting the switches, make absolutely sure that the power of the AC adapter
which is to be connected to the pan-tilt head is set to OFF.
OThe landing characteristics are not changed simply by selecting the switch positions.
They are changed only after the power is turned off and back on again after the switches
have been set.
Suspension Stand-alone