Filter
Top Products
21
G/L IN Pb OUT Pr /SDI
OUT
Y/VIDEO
OUT
1394
CONTROL IN
IP/RP
DC12V
IN
CAMERA I/F
LENSE I/F
ND/EXT
SDI
IN
CSOP
+-
LAMP
CONTROL
<
;
=
Connections
$Connecting the AC adapter for use with the pan-tilt head
Connect the pan-tilt head with the AW-PS300 AC adapter designed for use with the pan-
tilt head.
Approx. 1 cm
It is recommended that the tip be soldered.
AC adapter for use with the
pan-tilt head:
AW-PS300
;DC 12V IN terminal board
Connect this to the DC 15V OUT
connector on the AC adapter (AW-
PS300). (The voltage output from the
AC adapter is set to 15V: this takes into
consideration the voltage drops due to
the possible extension of the DC cable
between the pan-tilt head and AC
adapter.)
Make sure that the positive + and
negative - ends of the wires are
connected to the same signs on the
connector.
Use a cable with a nominal cross section
of 1.25 mm
2
or more which complies
with the Electrical Appliance and
Material Control Law for the connection.
<LAMP CONTROL terminal board
Connect this only when the power of a
halogen lamp is to be supplied from the
LAMP AC OUT connector on the AC
adapter (AW-PS300).
This connector is connected to LAMP
CONTROL on the AC adapter for the
pan-tilt head.
The symbols C and S on the wires must
match the same symbols on the
connector.
Use a cable with a nominal cross section
of 0.3 mm
2
or more that complies with
the Electrical Appliance and Material
Control Law for the connection.
=OP terminal board
Connect this only when the OP SW
CONTROL OUT connector on the AC
adapter (AW-PS300) is to be used.
Connect it to the OPTION SW
CONTROL IN connector on the AC
adapter (AW-PS300).
Use a cable with a nominal cross section
of 0.3 mm
2
or more that complies with
the Electrical Appliance and Material
Control Law for the connection.