Filter
Top Products
8
Parts and their functions
=Safety wire mounting hole
This is used when attaching a wire to
prevent the pan-tilt head from dropping.
>Base connector panel
This is used for connection with a
controller, multi-port hub or AC adapter
for the pan-tilt head.
?Blank side panel
This is used when changing the
mounting position of the base connector
panel.
@Blank bottom panel
This is used when changing the
mounting position of the base connector
panel.
1Tilting arm
This tilts in the vertical direction.
2Tilting arm fixing screws
M4a12 mm (4 screws supplied)
3Camera mounting plate
This is used to mount the convertible
camera.
4Guide screws
These are used to maintain the camera’s
balance and anchor the camera
mounting plate.
5Guide pin
This determines the mounting direction
of the camera.
6Guide roller
This serves as the fulcrum for
maintaining the camera’s balance.
7Camera mounting screws (U1/4˝-20
UNC)
These are used to mount the camera
and anchor it securely.
8Head
This rotates in the horizontal direction.
9Tally lamps (a2)
These light (red) in response to the
selection signals.
:Head connector panel
This is used for connection with the
camera and lens.
;Base
<Pan-tilt head mounting holes
These four holes are used for mounting
the pan-tilt head.