Filter
Top Products
16
Installation
(The installation work must be performed by your dealer without fail.)
OAttaching the chain
1. Attach one end of the chain to the
pan-tilt head using a chain attachment
screw (M4a8 mm: with flat
washer/spring washer).
2. Position the other end of the chain
over the screw hole on the top of the
camera and attach it using a chain
attachment screw (M4a6 mm: with
flat washer/spring washer).
<Notes>
OBe sure to tighten all screws firmly
with a screwdriver or similar tool.
OWhen the hole on the camera is M2.6,
attach the chain with the M2.6a6 mm
(with flat washer/spring washer) chain
attachment screw.
OWhen using the AW-E800A camera,
the mounting spacer must be attached
to the top panel of the camera before
attaching the chain. Position the end
of the chain over the hole on the
mounting spacer and attach it using a
chain attachment screw (M4a6 mm:
with flat washer/spring washer).
Be sure to tighten the mounting
spacer and all screws firmly with a
screwdriver or similar tool.
Chain
Chain
Chain attachment screw
M4a8 mm:
with flat washer/spring
washer
Chain attachment screw
M4a8 mm:
with flat washer/spring
washer
Chain attachment screw
M4a6 mm or M2.6a6 mm:
with flat washer/spring
washer
Chain
With the AW-E800A
Chain attachment screw
M4a8 mm:
with flat washer/spring
washer
Chain attachment screw
M4a6 mm:
with flat washer/spring
washer
Mounting spacer
(included with the
AW-E800A)
This chain is for use with the AW-E300,
AW-E600 and AW-E800A convertible
cameras. It cannot be used with any
other camera.
When attaching any other camera to the
pan-tilt head, carefully check the pan-tilt
head operation and that appropriate
measures have been taken to ensure the
camera does not fall.