Filter
Top Products
25
SDI IN
Pr/SDI OUT
O I
REMOTE
CONTROL OUT TO
PAN/TILT HEAD
G/L IN
G/L OUT
CONTROL IN IP/RP
Examples of connections
3. When controlling the camera and pan-tilt head using the AW-RP605 multi-function
controller and transmitting SDI signals
Color monitor
Pan-tilt head cable:
AW-CA50T29
Printed circuit board
switches:
SDI settings
Multi-Function Controller:
AW-RP605
AC adapter:
AW-PS300
OUse the camera/pan-tilt head connecting cable (AW-CA50T29) to connect the pan-tilt
head with the convertible camera in which an SDI card (AW-PB304), etc. has been
installed.
OSet the printed circuit board switches to the SDI settings.
OUse a coaxial cable (BELDEN 8281) to connect the SDI OUT connector on the
convertible camera with the SDI IN connector on the pan-tilt head. Select the coaxial
cable of a length at which the pan-tilt head will operate smoothly.
OUse a coaxial cable (BELDEN 8281) to connect the Pr/SDI OUT connector on the
pan-tilt head with the SDI IN connector on the color monitor.
OUse a 10BaseT straight cable (UTP category 5) to connect the CONTROL IN IP/RP
connector on the pan-tilt head with the CONTROL OUT TO PAN/TILT HEAD
connector on the controller.
OCheck that the pan-tilt head and camera can be controlled using the controller.
Coaxial cable:
BELDEN 8281, max. 3,280 feet
(1,000 meters)
Coaxial cable:
BELDEN 8281, max. 656 feet
(200 meters)
Coaxial cable:
BELDEN 8281
10BaseT straight cable:
UTP category 5, max. 3,280 feet
(1,000 meters)
Cable with a nominal cross
section of 1.25 mm
2
or more
max. 98.4 feet (30 meters)
Personal computer
(Windows)
Genlock signals must be supplied when
more than one camera and pan-tilt head
are to be used.