Filter
Top Products
17
Installation
(The installation work must be performed by your dealer without fail.)
OMounting a camera
When mounting a camera to the pan-tilt
head, take appropriate measures to
prevent the camera from falling or being
stolen.
1. Place the camera on the camera
mounting base and insert the guide
pin into the guide hole on the camera.
2. Tighten the 2 camera mounting
screws to fix the camera firmly in
place.
3. After mounting the camera, check that
it is firmly attached and that there is
no play.
<Notes>
OBe sure to tighten all screws firmly
with a screwdriver or similar tool.
OWhen there is only 1 hole on the
camera, remove the 2 camera
mounting screws from the camera
mounting base, then insert 1 camera
mounting screw into the center hole
on the camera mounting plate and
tighten it to fix the camera in place.
O
Adjusting slack in the chain
The chain length allows for some
degree of slack.
Remove any slack after attaching the
camera to the pan-tilt head by twisting
the chain around as shown in the figure
at right, then firmly tighten the screw to
fix it in place.
Camera mounting
Screw
Camera guide pin
Camera mounting Screw
With the AW-E800A