A SERVICE OF

logo

16 C2688M-C (12/08)
NETWORK CONNECTION
NOTE: Consult your network administrator before installing the data interface to avoid possible network conflicts.
Use the network port on the front panel and a Cat5e (or better) cable with RJ-45 connectors to connect the data interface to your system
network.
Figure 13. Connecting the EDI5000 to the Endura Network
POWER CONNECTION
To connect power, complete the following steps:
1. Connect a power supply to the data interface. The data interface can be powered from many sources, as described in Power Supply Options
on page 17.
2. Connect power to the power supply. The Pelco badge (blue) on the front panel should glow.
Figure 14. Connecting Power
EDI5
000
IOIO
I 2
IO
IO
I 1
NETWORK
4-PIN
CONNECTOR
ADAPTER