Filter
Top Products
C2688M-C (12/08) 9
Installation
HARDWARE INSTALLATION OVERVIEW
The following steps provide an overview of how to install the data interface:
1. Install all components of the matrix switching system (refer to the matrix system documentation for instructions).
2. Install the EDI5000 data interface, and then make the following connections (instructions are provided in this Installation section):
a. Connect the data interface to the matrix system keyboard.
b. Connect the data interface to the Endura network.
NOTE: If the matrix system includes more than one keyboard, you can install one data interface unit for each matrix keyboard.
3. Install all components of the Endura system and connect all components to the network (refer to the Endura system documentation for
instructions).
NOTE: The EDI5000 is compatible with Endura version 1.03 or later components (NVR5000 and SM5000); Endura decoders must be version
1.04.0032 or later.
4. Connect the appropriate Endura devices to the matrix system, as follows (refer to the matrix system documentation and the Endura system
documentation for instructions):
• Endura recording system: When using Endura to record video from the matrix system, you need the following video connections:
– Analog video from each matrix system camera must be looped from the matrix system to Endura encoders (refer to the matrix
system documentation for instructions on looping video).
– Recorded video from Endura decoders (using the monitor output connector) must be routed to the matrix; use the video input
connectors on the matrix system.
• Endura expansion system: If you are using Endura to expand the number of cameras that can be viewed in the matrix system, you
need an analog connection between each Endura decoder and the matrix system; use the video input connectors on the matrix system.
Be sure that the distance between the Endura device and the matrix system video connectors is less than the maximum distance for the
coaxial cable.
Once the hardware installation and device connections are completed, you must configure the data interface software. Refer to Software
Configuration on page 20.
BEFORE YOU BEGIN
Since Endura is a network system that requires a continuous amount of bandwidth to transmit live video, always include your network
administrator when planning and installing Endura components. In addition, you will need Pelco-approved Endura certification.
PARTS LIST
NOTE: Since power requirements vary by installation, an individual power supply is not included with the data interface. You can purchase
either the NET5301PS single unit power supply or the RK5100PS-5U rack mount, which includes a power supply. Refer to Power Connection on
page 16 for more information.
Qty Description
1 EDI5000 data interface
4 Rubber mounting feet
1 10-pin terminal block
1 4-pin to 2-pin power adapter
1 Pelco badge rotation sticker
1 Small flat-tip screwdriver