Filter
Top Products
SERIAL COMMAND SET
Serial Command Set Usage
May 9, 2002 SuperView 3000 User Manual 35
.....
SERIAL PORT FUNCTIONS
These commands control the baud and echo settings.
MISCELLANEOUS
These commands control a variety of general SuperView functions.
Command Arguments Description
BAUDrate <1200 | 2400 | 9600 | 19200 |
38400 | 57600 | 115200>
Sets the serial port baud rate. The value is
automatically saved in NVRAM.
Factory default: 9600
ECHO <ON | OFF> Turns the serial echo On/Off. The value is saved in the
NVRAM. The echo is only on commands typed and
sent to the unit.
Note: Echo setting has no effect on responses issued
by the SuperView; responses are always visible,
regardless of the echo status.
Factory default: ON
Command Arguments Description
AUTOSAVE <ON | OFF> The AutoSave feature automatically stores the system
configuration approximately every ten seconds. The
process stores configuration information such as
HostList, InputList, Host settings, and display
parameters. AutoSave allows you to turn the NVRAM
automatic update mode on or off.
Factory default: ON
DEMO (none) Demo runs the built-in demo sequence. Type “q” to quit
demo.
FrontPanel <ON | OFF> Enables and disables the front panel.
Factory default: ON
Help [<command>] Help, without an argument will display the entire serial
command set. Help,withacommandasanargument
will display detailed information about that command.
ID (none) Displays the product identification, product name,
firmware version number, date, and serial number.
PRESET <1...6> Stores your current screen configuration to the
designated preset position. This configuration includes
window size, position, and order, image parameters,
input timing parameters, and output timing parameters.
You can reload these presets using the Recall command.
RECALL <1...6> [<all>] Recalls a previously saved preset configuration.
Without the ALL argument, the SuperView recalls only
the position, size, and priority level for each input
window.
With the ALL argument, the SuperView recalls all of the
parameters stored in the EEPROM (i.e. input type
selection, image controls, etc.). This option will take
more time since more parameters are being recalled.
RestoreFactoryDefaults (none) Restores all user settings to their factory default values.