Filter
Top Products
120
Shooting Functions > Flash
Setting wireless sync for internal or external ash
Set wireless sync to control internal and external ash units remotely
via wireless signals. The remote system consists of a master ash that is
mounted on the camera and one or more slave ash units. A slave ash is
assigned to one of three groups: A, B, or C.
To set wireless
sync,
In Shooting mode, press [m]
ĺ
b
ĺ
Internal Wireless
Flash or External Wireless Flash
ĺ
an option.
* Default
Option Description
Use Wireless
Flash
Set to use wireless sync. (O*, On)
Channel
Select channels for wireless sync. There are four remote
channels available to allow multiple remote systems to
operate at the same time. Master and slave ash units, in
the same remote system, must be set to the same channel.
(Ch. 1, Ch. 2, Ch. 3, Ch. 4)
Group Flash
Mode
Set the ash mode for group A, B, or C. Changes to the
ash mode must be made on the master ash. The
changes are then applied to slave group A, B, or C, and
the slave groups operate as a remote system of the ash
mode (TTL or manual) according to the settings for the
master ash.
• A-TTL: Set the exposure of the ash when the ash
mode is A-TTL.
• Manual Flash: Set the brightness of the ash when the
ash mode is Manual Flash.
• O: Do not re the ash.
•
You cannot select External Flash Settings when you use the External
Wireless Flash function.
•
For information about using the wireless sync feature with an external ash,
refer to the optional external ash’s (SEF-580A) user manual.