Filter
Top Products
准备
使用锂离子电池组
仅使用SB-LSM80或SB-LSM160（不提供）锂离子电池组。
电池组在购买时可能只有一点电能。
给锂离子电池组充电
1. 旋转[Power]开关到[OFF]状态。
2. 把锂离子电池组安装在摄录机上。
3. 连接AC Power适配器（AA-E9型）到电
源插座。
4. 打开 DC IN 插孔盖。
5. 将DC电缆连接至DVD摄像机上的DC IN插
孔。
充电指示灯器开始闪烁，锂电池组
开始充电。
6. 当电池已完全充电，可从DVD摄像机断
开电池组与交流电源适配器的连接。在
机器上时，即使电源状态开关拨到Off
位置，电池组也会放电。
闪烁时间 充电率
一秒闪烁一次 小于50%
一秒闪烁二次 50%
~
75%
一秒闪烁三次 75%
~
90%
闪烁停止充电灯常亮 90%
~
100%
充电灯亮一秒灭一秒
错误-重新安装锂电池组和重
新插入直流电源线
Preparation
Using the Lithium Ion Battery Pack
Use SB-LSM80 or SB-LSM160 (not supplied) Battery Pack only.
The Battery Pack may be charged a little at the time of purchase.
Charging the Lithium Ion Battery Pack
1. Turn the [Power] switch to [OFF].
2. Attach the Battery Pack to the DVD
Camcorder.
3. Connect the AC Power adapter(AA-E9
TYPE) to a wall socket.
4. Open the DC IN Jack Cover.
5. Connect the DC cable to the DC IN jack
on the DVD Camcorder.
The charging indicator will start to
blink, showing that the Battery is
charging.
6. When the Battery is fully charged,
disconnect the Battery Pack and the
AC Power Adapter from the DVD
Camcorder. Even with the Power
switched off, the Battery Pack will still
discharge.
Blinking time Charging rate
Once per second Less than 50%
Twice per second 50% ~ 75%
Three times per second 75% ~ 90%
Blinking stops and stays on 90% ~ 100%
On for a second and off for a
second
Error - Reset the Battery Pack
and the DC Cable
中 文
21
ENGLISH
<Charging indicator>
5
Power Switch