Filter
Top Products
Sending an Image Using a Rapid Key or Speed Dial Number
23
Sending an image using a Speed Dial number
Use this procedure to scan a document and send the image to an E-
mail, FTP, or Desktop destination that has been stored in a Speed Dial
number.
Important: To use this procedure, the setup procedures outlined on
page 4 must be completed. In the case of Scan to E-mail, this includes
setting a default sender as explained in the procedure beginning on
page 16 of this manual.
♦ If you are sending the image to an e-mail destination and need to
change the subject, use the procedure on page 16.
1
Load the document(s).
• SEND READY will appear in the
display.
• Press and/or to
set the resolution and contrast if
needed. The default resolution is
FINE. Note that STANDARD and
SUPER FINE are primarily for
faxing and are not recommended
for scanning.
2
Press and then enter the Speed Dial number by pressing
the numeric keys.
• If you enter less than 3 digits for the Speed Dial number, press
to complete the entry.
• Check the display to make sure the destination shown is correct (if
not, press and repeat Step 2).
RESOLUTION
CONTRAST
SPEED DIAL
START/
ENTER
STOP