Filter
Top Products
Page 54 SonicWALL SRA 1200/4200 Appliance Regulatory Statement and Safety Instructions
SonicWALL SRA 1200/4200 Appliance
Regulatory Statement and Safety
Instructions
This regulatory information can also be found in the electronic file,
“SonicWALL_SRA_Regulatory_Statement.pdf,” located on the
SonicWALL Web site: <
http://www.sonicwall.com>.
The above SonicWALL appliances are designed to be mounted in a
standard 19-inch rack mount cabinet. The following conditions are
required for proper installation:
• Use the mounting hardware recommended by the rack
manufacturer and ensure that the rack is adequate for the
application.
• Four mounting screws, compatible with the rack design, must be
used and hand tightened to ensure secure installation. Choose a
mounting location where all four mounting holes line up with those
of the mounting bars of the 19-inch rack mount cabinet.
• Mount in a location away from direct sunlight and sources of heat.
A maximum ambient temperature of 104º F (40º C).
• Route cables away from power lines, fluorescent lighting fixtures,
and sources of noise such as radios, transmitters and broadband
amplifiers.
• The included power cord is intended for use in North America only.
For European Union (EU) customers, a power cord is not included.
• Ensure that no water or excessive moisture can enter the unit.
• Allow unrestricted airflow around the unit and through the vents on
the side of the unit. A minimum of 1 inch (25.44mm) clearance is
recommended.
• Mount the SonicWALL appliances evenly in the rack in order to
prevent a hazardous condition caused by uneven mechanical
loading.
• If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be greater than
room ambient temperature. Therefore, consideration should be
given to installing the equipment in an environment compatible
with the maximum recommended ambient temperature shown
above.
• Consideration must be given to the connection of the equipment to
the supply circuit. The effect of overloading the circuits has
minimal impact on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings must
be used when addressing this concern.
• Reliable grounding of rack-mounted equipment must be
maintained. Particular attention must be given to power supply
connections other than direct connections to the branch circuits
such as power strips.
Lithium Battery Warning
The Lithium Battery used in the SonicWALL Internet security appliance
may not be replaced by the user. The SonicWALL must be returned to a
SonicWALL authorized service center for replacement with the same or
equivalent type recommended by the manufacturer. If, for any reason,
the battery or SonicWALL Internet security appliance must be disposed
of, do so following the battery manufacturer's instructions.
Cable Connections
All Ethernet and RS232 (Console) cables are designed for intra-building
connection to other equipment. Do not connect these ports directly to
communication wiring or other wiring that exits the building where the
SonicWALL is located.
Regulatory Model/Type Product Name
1RK23-088
1RK23-07C
SonicWALL SRA 1200
SonicWALL SRA 4200