Filter
Top Products
27 (GB)
You can set the HSR-X200/X200P to perform
recording during a specified time every day or on a
specified day of the week.
Up to eight sets of timer recording can be specified.
On the days specified as holidays with HOLIDAY
SET, timer recording will be made with the same
conditions as those set for Sunday.
In timer recording, data will be recorded in the normal
recording area with the same picture quality as
selected for normal recording.
Before you activate timer recording
Be sure that the built-in clock has been correctly set.
Clock setting can be achieved with LANGUAGE/
CLOCK SET of MAIN MENU 1
(page 44(GB)).
Settings for Timer Recording
The day of the week and starting/ending times are to
be specified to activate timer recording.
Use TIMER SET of MAIN MENU 1.
<TIMER SET>
WEEK START STOP REC CYCLE SET
SUN --:-- --:-- -- SEC(----H) OFF
MON 08:00 18:00 A 0.05 SEC( 14H) ON
THE 08:00 18:00 A 0.10 SEC( 27H) ON
WED 08:00 18:00 0.20 SEC( 54H) ON
THU 08:00 18:00 A 0.07 SEC( 18H) ON
FRI 08:00 18:00 30 SEC(9999H) OFF
SAT --:-- --:-- -- SEC(----H) OFF
DLY --:-- --:-- -- SEC(----H) OFF
START: Set the time to start recording (hours and
minutes in sequence).
STOP: Set the time to stop recording (hours and
minutes in sequence).
REC CYCLE: Select the recording cycle.
SET: To activate timer recording specified on this
line, set to ON.
The same picture quality selected for normal recording
is used for timer recording. When you select REC
CYCLE, the possible recording time is automatically
calculated and displayed in parentheses (max. 9999).
When audio recording is valid, “A” appears before the
REC CYCLE value.
Setting procedure
1 Press the MENU button to display MAIN MENU 1
on the monitor screen.
2 Turn the Jog dial to highlight 6. TIMER SET and
turn the Shuttle dial clockwise.
The TIMER SET display appears.
3 Turn the Jog dial to highlight the line to be set and
turn the Shuttle dial clockwise to finalize your
selection.
The WEEK column of the selected line flashes.
4 Turn the Jog dial to set the day of the week and
turn the Shuttle dial clockwise to register the
setting.
To record with the same condition every day, set to
DLY.
The left field of the START column flashes.
5 Set the remaining items on the line using the Jog
and Shuttle dials.
To perform timer recording over two days
Use the lowest two lines.
Set the day and time to start recording on the upper
line and those to stop recording on the lower line.
Example:
SAT 19:00 --:-- -- -- SEC(----H) ON
MON --:-- 06:00 A 0.05 SEC( 14H) ON
6 If you next wish to set holidays, press the MENU
button to advance to the HOLIDAY SET display
(next page).
To end the settings, press the EXIT/OSD button.
Timer Recording