Filter
Top Products
2
Table of Contents
To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or
moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified
personnel only.
For the customers in the U.S.A.
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority to
operate this equipment.
All interface cables used to connect peripherals must be
shielded in order to comply with the limits for a digital device
pursuant to Subpart B of Part 15 of FCC Rules.
For the customers in Europe
This product with the CE marking complies with both the EMC
Directive and the Low Voltage Directive issued by the
Commission of the European Community.
Compliance with these directives implies conformity to the
following European standards:
• EN60950-1: Product Safety
• EN55103-1: Electromagnetic Interference (Emission)
• EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following
Electromagnetic Environments:
E1 (residential), E2 (commercial and light industrial), E3
(urban outdoors), E4 (controlled EMC environment, ex. TV
studio).
The manufacturer of this product is Sony Corporation, 1-7-1
Konan, Minato-ku, Tokyo, Japan.
The Authorized Representative for EMC and product safety is
Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327
Stuttgart, Germany. For any service or guarantee matters
please refer to the addresses given in separate service or
guarantee documents.
For the State of California, USA only
Perchlorate Material - special handling may apply, See
www.dtsc.ca.gov/hazardouswaste/perchlorate
Perchlorate Material : Lithium battery contains perchlorate.
For the customers in Taiwan only
Table of Contents
Overview ................................................................... 3
Features ..........................................................................3
System Configuration ......................................................4
Standalone operation example ..................................4
System operation example (with a Camera Control
Unit) .......................................................................5
Parts Identification ...........................................................5
Front right ..................................................................5
Front left ....................................................................6
Rear ...........................................................................7
Operation panel .........................................................7
Connector panel ........................................................8
Installation ................................................................ 9
Connecting a Camera Control Unit (CCU) ......................9
Attaching a Lens ...........................................................10
Attaching a Viewfinder ..................................................10
Attaching a Microphone ................................................11
Mounting the Camera to a Tripod .................................12
Adjusting the Shoulder Pad Position .............................13
Preparatory Settings .............................................. 13
Adjusting the Black Balance and White Balance ..........13
Setting the Electronic Shutter ........................................14
Setting the Local Time ..................................................15
Adjusting the Flange Focal Length ................................15
Setting the Focus Assist Function .................................16
Setting the Camera Outputs ..........................................17
Outputting a Trunk Signal .............................................18
Basic Procedure for Shooting............................... 19
Menus...................................................................... 20
Displaying Menu Pages ................................................20
Setting the Menu ...........................................................20
Editing the USER Menu ................................................21
OPERATION Menu .......................................................24
PAINT Menu ..................................................................28
MAINTENANCE Menu ..................................................30
FILE Menu .....................................................................32
DIAGNOSIS Menu ........................................................34
Appendices............................................................. 34
Precautions ...................................................................34
Error Messages .............................................................35
Using a “Memory Stick” .................................................35
Specifications ................................................................36
Menu Tree .....................................................................38
WARNING