Filter
Top Products
207
Additional Information
Maintenance information and precautions
CALIBRATE
(2) Remove dust from inside the eyecup and viewfinder with a commercially
available blower.
(3) In the reverse way of (1), attach the eyecup.
Caution
Do not remove any other screws. You may remove only the screw to remove the eyecup.
Notes
•Do not drop or bend the eyecup shaft.
•Be careful when handling the eyecup.
Charging the built-in rechargeable battery
Your camcorder has a built-in rechargeable battery so that the date, time and other
settings are retained even when the POWER switch is set to OFF (CHG). The built-in
rechargeable battery is always charged as long as you are using your camcorder. The
battery, however, will get discharged gradually if you do not use your camcorder. It
will be completely discharged in about 4 months if you do not use your camcorder at
all. Even if the built-in rechargeable battery is not charged, it will not affect your
camcorder operation. To retain the date and time, etc., charge the battery if the battery
is discharged.
Charging the built-in rechargeable battery
•Connect your camcorder to the house current using the AC Adaptor supplied with
your camcorder, and leave your camcorder with the POWER switch set to OFF (CHG)
for more than 24 hours.
•Or install the fully charged rechargeable battery pack on your camcorder, and leave
your camcorder with the POWER switch set to OFF (CHG) for more than 24 hours.
Adjusting the LCD screen (CALIBRATION)
The buttons on the touch panel may not work correctly. If this happens, follow the
procedure below.
(1) Set the POWER switch to OFF (CHG).
(2) Eject the tape from your camcorder, then disconnect any connecting cable from
your camcorder.
(3) Set the POWER switch to VCR while pressing DSPL/BATT INFO on your
camcorder, then keep pressing DSPL/BATT INFO for about 5 seconds.
(4) Touch
displayed on the screen using an object such as the corner of a
"Memory Stick.”
The position of
changes.
Notes
•If you do not press the right spot, start from step 4 again.
•You cannot calibrate the LCD screen when the LCD screen is facing out.