Filter
Top Products
MPEG-2 Configuration
VBrick MPEG-2 Appliance Admin Guide 43
Dedicated Address Mode
When the Passthrough State is set as Initiator and the Destination is Dedicated, the VBrick
appliance can be configured and identified using either an IP address or Host Name.
Configuration: Passthrough > COM2
Passthrough settings for COM2 are a subset of COM1. See Configuration: Passthrough >
COM1 for complete details. As noted, DTR and RTS are not available for COM2. Under no
conditions are RTS or DTR controls passed through end-to-end. All control handling is
local.
Configuration: System
This menu allows the user to set-system related parameters.
Operational State Describes the current status of a Passthrough connection, including
error conditions, if any. Refer to the Network Status Section. This will
display
Active if in Passthrough mode.
Idle Time out 5–2000 milliseconds. Default = 500. The interval between characters
at which metadata is inserted into the stream.
COM Interface
Type
Describes the COM interface connector. (RS422/485 options are
displayed only if main board has a Part Number ending in xxx3. See
Status: User Information > Main Board.)
• RS232 – standard RS-232 serial port connector.
• RS422/485 – RS-422/485 4-wire serial port connector.
• RS422/485 (Terminated) – RS-422/485 terminated.