Filter
Top Products
Setting the Auto Pan Speed
1. Press and hold A/P key.
2. Move joystick to Pan Right until the desired speed is observed on the monitor.
3. Release the A/P key.
4. Release the joystick
Activating Auto Pan
Auto Pan allows the dome to continuously pan between the left and right scan limit settings. To start
Auto Pan, press the A/P key. If no scan limit settings are programmed, the dome pans to the right
continuously.
Note: Auto Pan will be cancelled if the operator issues a Pan, Flip, Preset, or
Pattern command.
Wiring Configurations
In Vicon systems where the domes support loop through, daisy chain the SpeedDome Ultra VII
domes off the last Vicon dome in the communications chain.
Figure F-1: SpeedDome Ultra VII dome loop-through wiring from Vicon dome
To controller or
other domes
In Out In Out
Command Response
Vicon dome
SpeedDome
Ultra VII dome
SpeedDome
Ultra VII dome
Vicon Protocol Command Summary F–5