Filter
Top Products
Command Summary
The following table lists the commands to operate the configuration utility when the dome is installed
in a SensorNet or RS-422 environment.
If you want to … Use …
Start the configuration utility.
Press and hold Iris Open,
press and hold a Focus
button, then press Zoom
Out*
Move the highlight bar on the active menu.
Pan/Tilt
Select the highlighted item on the active menu.
Focus
Increase the value of the selected setting. For example, Red or
Blue white balance values.
Zoom In
Decrease the value of the selected field. For example, Red or
Blue white balance values.
Zoom Out
Display the next choice for the setting. For example,
Maximum Zoom setting.
Zoom In
Display the previous choice for the setting. For example,
Maximum Zoom setting.
Zoom Out
Save changes and exit the utility from any screen.
Iris Close, then Focus*
Manually activate or deactivate IR mode.
Press and hold Iris Open,
press and hold Focus
Far, then press Focus
Near*
* These commands not supported with MPLT with ADCC0200 or ADCC0300 controller. Refer to the appropriate
operator’s manual for instructions.
Setting Names / Working with Passwords
When setting names or entering password information, the screen displays the available characters in
the selected languages. In these situations, the following commands are used:
If you want to … Use …
Move the highlight left or right in the character field.
Pan
Move the highlight up or down in the character field.
Tilt
Select the highlighted character in the character field.
Focus
Move the cursor to the right of the current character in the
name or password.
Zoom In
Move the cursor to the left of the current character in the
name.
Zoom Out
A–2 SpeedDome Ultra VII Day/Night Operator's Manual