Filter
Top Products
55
AXIS 233D - System Options
Resetting to Factory Default Settings
To reset the AXIS 233D to the original default settings, go to the System Options >
Maintenance web page (described in
Maintenance, on page 52) or use the control button
on the AXIS 233D as described below:
This will reset all parameters, including the IP address, to the Factory Default settings:
1. Remove dome of camera. See Installation Guide for instructions.
2. Press and hold the red and black buttons at the same time. Release the red restart
button, but continue to hold down the black control button.
3. Hold down the black control button until the status indicator flashes amber (this may
take up to 15 seconds).
4. Release the black control button.
5. When the status indicator displays green (which can take up to 1 minute) the process
is complete and the camera has been reset to factory default.
6. Re-assign the IP address in the AXIS 233D using one of the methods described in
this document.
Red Restart Button
Status LED Indicator
Black Control Button