Filter
Top Products
22 en | Installing the DINION capture DINION capture 5000 IP
| 1.0 | 2012.01 Installation Manual Bosch Security Systems, Inc.
should be anchored in concrete or welded to a steel backer
plate.
Refer to the MBE Mounts and Adapters Installation Guide for
more details about attaching the bracket to an MBE-15 Pole
Mount Adapter or to the MBE-17 Wall Mount Adapter.
1. Use the wall mount template supplied in the packaging box
to locate the four mounting holes for the camera bracket.
2. Drill four (4) holes for the mounting bolts. If installing
outdoors, apply a weatherproof sealant around each hole
at the mounting surface.
3. Route the cable. If routing the cable through the wall, drill
a 25.4 mm (1 in.) hole following the wall mount template
and use a weatherproof sealant to seal around the cable to
ensure a weather tight seal between indoors and outdoors,
otherwise route the cable through one of the side holes in
the mounting bracket by removing the plug and routing the
cable through.
4. Secure the mounting bracket to the mounting surface. Use
four (4) corrosion-resistant, stainless steel studs or bolts,
nuts, washers, and lock washers (not supplied).
5. Adjust the license plate camera angle using the range and
angle recommendations in Section 3.1 Determining the
Range, page 19.
– Connect the imager to a local monitor to assist
adjusting the license plate camera. For DINION
capture 5000 IP cameras, refer to Section 3.4.3 Video
Connection for Installation, page 25.
WARNING!
A stud/bolt diameter of 6.0 mm (or 1/4 inch) able to withstand
a 300 kg (660 lb) pull-out force is recommended. The mounting
material must be able to withstand this pull out force.