Filter
Top Products
DINION capture 5000 IP Installing the DINION capture | en 27
Bosch Security Systems, Inc. Installation Manual | 1.0 | 2012.01
3.6 Connecting to a Coax Cable
You can temporarily connect the DINION capture 5000 IP to a
monitor via a coax cable to view the transmitted image for
setup and testing purposes.
1. Remove the four (4) hex socket screws from the back
panel using the supplied 3 mm hex key.
2. Locate the BNC connector (item 1, below) inside the
imager and connect a coax cable.