Filter
Top Products
36 en | Configuration DINION capture 5000 IP
| 1.0 | 2012.01 Installation Manual Bosch Security Systems, Inc.
4.2.3 Network submenu
To operate the DINION capture 5000 IP in your network, a
network-valid IP address must be assigned. The factory default
IP address is 192.168.0.1.
The new IP address, subnet mask, and gateway address are set
when leaving the menu. The camera reboots internally and the
new values are set after a few seconds.
4.2.4 Default submenu
Item Selection Description
IP Address Enter an IP address for the camera.
Use LEFT/RIGHT to change position in
the address, use UP/DOWN to select
the digit. Use SELECT to exit the
address edit screen.
Subnet Mask Enter the Subnet mask (default
255.255.255.0).
Gateway Enter a Gateway address.
DHCP If the network has a DHCP server for
dynamic IP address allocation, set this
parameter to On to activate the
automatic acceptance of DHCP-
assigned IP addresses.
EXIT Returns to Install menu.
Item Selection Description
Restore All? No, Yes Restores all settings of the six modes
to their default (factory) values. Select
YES then press the Menu/Select
button to restore all values.
When completed the message
RESTORED! is shown.