Filter
Top Products
86 en | Advanced Mode DINION capture 5000 IP
| 1.0 | 2012.01 Installation Manual Bosch Security Systems, Inc.
8.6 Alarm
8.6.1 Alarm Connections
Select the response of the camera when an alarm occurs. In the
event of an alarm, the device can automatically connect to a
pre-defined IP address. The device can contact up to ten IP
addresses in the order listed until a connection is established.
Connect on alarm
Select On so that the camera automatically connects to a pre-
defined IP address in the event of an alarm. Select Follows
input 1 so that the device maintains the connection for as long
as an alarm exists.
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the
event of an alarm. The device contacts the remote locations one
after the other in the numbered sequence until a connection is
made.
Destination IP address
For each number, enter the corresponding IP address for the
desired remote station.
Destination password
If the remote station is password protected, enter the
password here.
Alarm
> Alarm Connections
>VCA
>Audio Alarm
>Alarm E-Mail
>Alarm Task Editor
NOTICE!
Alarm Input 1 is reserved for Automatic Mode Switching.
Changes in the alarm settings may affect the operation of the
Automatic Mode Switching. Modify settings with discretion.