Filter
Top Products
24 en | Installing the DINION capture DINION capture 5000 IP
| 1.0 | 2012.01 Installation Manual Bosch Security Systems, Inc.
3.4 Preparing the Wiring
The DINION capture 5000 IP is pre-wired with a 2-m long power
input lead and 10/100 Ethernet cable with a male RJ45
connection. The DINION capture 5000 IP can accept power via
the Ethernet cable compliant with the Power-over-Ethernet+
(PoE+ IEEE 802.3at) standard or from a Class 2 power supply.
NOTICE!
For purposes of evaluation and testing of the mounting
bracket's integrity under static loading at CSA, the unit was
mounted to a drywall surface as per the procedures below:
– Locate a stud in the wall and mark the outside edges of the
stud.
– Using the wall mount bracket as a template, align the
mounting hole with the center of the stud.
– Mark the point on the wall in the center of the hole where
the mounting bolt will be positioned.
– Remove the wall mount bracket and drill a pilot hole at the
marked point.
– Align the wall mount bracket mounting hole with the hole
drilled in the wall.
– Using a screwdriver, secure the wall mount bracket by
screwing a 2.5 in. screw with washer securely into the
stud.
– Follow this procedure to attach the three remaining
screws.
NOTICE!
The camera has not been evaluated for safety requirements
using other mounting kits.
CAUTION!
Before proceeding, disconnect the power from the power
supply cable. Ensure that the voltage of the unit matches the
voltage and type of the power supply being used.