Filter
Top Products
DINION capture 5000 IP Installing the DINION capture | en 29
Bosch Security Systems, Inc. Installation Manual | 1.0 | 2012.01
1. Remove the back panel of the DINION capture 5000 IP.
Refer to Section 3.6 Connecting to a Coax Cable, page 27 for
instructions.
2. Slide the SD card into the slot, located near the center of
the imager.
3. Replace the rear panel.
4. Refer to Section 8.5 Recording, page 78, for more
information on using the microSD card.
3.8 Resetting the DINION capture 5000 IP
You may need to restore the default IP address or restore a
previous version of the Bosch Video over IP (BVIP) firmware on
the DINION capture 5000 IP.
To reset the imager: